Fabulous Fedtech Feels like Florida

It's been so warm here in Minnesota, it may just get confused for Florida... We've been loving the weather and it finally feels like Spring time is here! Most snow is melted and if you ignore the otherwise constant rain we've been getting, it's kind of nice!

Things inside the shop have been moving right along. The new press brake has been working wonders with armor plating and with it, we've been pressin on. (pun intended) The waterjets have been busy with mostly gaskets and flanges (both large and small) these days. The lasers have been pretty focused on thin aluminum projects along with some stainless steel work. Most of the mind-boggling work comes off the waterjets, since they can cut through a variety of material types and thicknesses.

I've been pretty busy designing the new website and putting the finishing touches on it before it goes into production. I can't give any secrets out, but let's just say that it will look like a whole new website... I'm VERY excited - the makeover is long past due.

View our website 5 years ago   -   View our current website


QUESTIONS OF THE WEEK

Q) I have 1/2" stainless steel, should I use laser or waterjet?
A) It depends on when you'd need the parts. Sometimes lead times vary depending on how busy the waterjets or lasers are. However, if the lead times are equal, you might opt to use laser cutting as it often times costs less. At the same time, laser cutting does entail heat affected zones, so depending on the application, you may want to look into weighing the pro's and con's of each here.

Q) Can aluminum be cut with water-only waterjet?
A) Although tempting, you're not going to want to proceed with that idea. Water-only waterjet would leave rough edges on aluminum and is not able to cut through the material like abrasive waterjet can. Aluminum is better left for abrasive waterjet or laser cutting (depending on the thickness).

Q) I have a retail design that I'd like to cut from glass, can I do this with waterjet?
A) Absolutely. We've cut glass with abrasive waterjet before and can definitely look at your prints to see if your project is another success story waiting to happen.

Q) What are the odds of warping material when using waterjet vs. laser cutting?
A) Waterjet will not warp the material, and seldom does laser cutting warp material.


That's all the time that I have this week for questions. Now I have to end this here, but check back for more updates soon!

Ta ta for now,

Sarah